MODENGY 1001
Anti-friction solid-film coating with molybdenum disulfide and graphite
It is used in sliding guideways of the machine tools, flat springs, threaded connection of the bus-based machine tools, splined joints of the equipment's driving shafts, matrixes, and punches of the bending equipment
Package sizes:
MODENGY 1001 in action
Additional expendable materials
and equipment
- MODENGY Special Cleaner-Activator is intended to clean, degrease, activate surfaces
- MODENGY 1013 Special Solvent to rinse the equipment after the coating is applied, to remove uncured coating, to control completeness of coating polymerization
- MODENGY M1-250 Spray gun - to apply MODENGY anti-friction solid-film coatings
Advantages
- Low friction coefficient
- High load-carrying ability
- Wide service temperature range
- Workability in dusty environment
- High adhesion
- It prevents stick-slip motion
- Long service life (dependent on the unit construction – durable lubrication)
- It has properties of anti-emergency lubrication
- It speeds up parts assembly with robots
- It cures fast at room temperature
- It is available in aerosol package
Features
- It has a marked chalking effect at contact (solid lubricant particles transfer onto the mated surface)
- It is intended to operate under conditions of dry friction in absence of other lubricating materials and technical liquids
- It has high antiscuffing and lubricating properties
- It is not intended for corrosion protection
Specifications
- Colour: grey-black
- Service temperatures range: -180 … +440 °С
- Standard coating consumption: 100 g / m²
- Cure temperature / time: +23 °С / 15 min
Applying the coating by your own
Use to prepare and clean the surface. Only it guarantees good adhesion
Keep shaking the aerosol can with the coating for at least 3 minutes after you hear tapping of a little ball inside it
Spray the coating from the aerosol can onto the surface to be treated from the distance of 20 to 30 cm
Let the coating dry for at least 10 min. at room temperature until opacity appears (it’s the interim air-drying stage)
Apply the second layer of the coating over the dried previous one, if necessary
Let the coating dry for at least 15 minutes at room temperature (it’s the final air-drying stage)